Intel GA-8IPXDR-E - Manual (Page 16)

1 6
GA-8IPXDR-E(C) Motherboard
Installation Step:
1. The DIMM slot has a notch, so the DIMM
memory module can only fit in one direction.
2. Insert the DIMM memory module vertically into
the DIMM slot. Then push it down.
3. Close the plastic clip at both edges of theDIMM
slots to lock the DIMM module.
4. When installing the memoryin the DIMM
module, please insert them pair by pair.
You must follow the slot number order to
insert the DIMM into DIMM module.
The installation number sequence are
J3J6 -- J2J5 -- J1J4. If you only insert one
pair, you must insert it in J3/J6 slot.
5. If you want to install X4, X8 device width DDR
DIMMs simultaneously, please populated x4
device width DIMMs at the farthest DIMMs
away from MCH.
6. It is not not recommended to use DDR X4,
X8 type of mixture installation.
7. DIMMs must be populated in pairs, and the
DIMMs in a pair must be identical.
8. Reverse the installation steps when you wish to
remove the DIMM module.
J4 (B-1)
J1 (A-1)
J5 (B-2)
J2 (A-2)
J6 (B-3)
J3 (A-3)