Invacare Top End Terminator Jr. - Manual (Page 13)

13
REPLACING STANDARD BACK
UPHOLSTERY (FIGURE 4)
1. Remove the back height adjustment screws that
secure the back cane to the back upright.
2. Slide the back assembly out of the back uprights.
3. Remove the two (2) screws and washers that se-
cure the EXISTING back upholstery to the back
cane.
4. Slide the EXISTING back upholstery down and
off the back canes.
5. Slide the NEW back upholstery up and onto the
back canes.
6. Align the mounting hole in each back cane with
the desired mounting hole in each back upright.
NOTE: Both back canes should be adjusted to the
same height.
7. Install the two (2) back height adjustment screws
through the back upright mounting holes determined
in STEP 6 and the back cane mounting holes.
ADJUSTING THE BACK HEIGHT
(FIGURE 3)
NOTE: If necessary, remove the back upholstery to
access mounting holes. Refer to REPLACING STAN-
DARD BACK UPHOLSTERY or REPLACING CUS-
TOM MANUAL ADJUSTABLE TENSION BACK UP-
HOLSTERY in this procedure of the manual.
1. Remove the back height adjustment screws that
secure the back cane to the back upright.
2. Raise/lower the back canes to the desired height.
3. Align the mounting hole in each back cane with
the desired mounting hole in each back upright.
NOTE: Both back canes should be adjusted to the
same height.
4. Install the two (2) back height adjustment screws
through the back upright mounting holes determined
in STEP 3 and the back cane mounting holes.
FIGURE 3 - ADJUSTING THE BACK HEIGHT
Back
Height
Adjustment
Screw
Back
Uprights
Back
Canes
Mounting
Holes
NOTE: Standard back upholstery shown for clarity.
Back
Height
Adjustment
Screw
Mounting
Screw
Washers
Back Upholstery
Back
Uprights
Mounting
Screw
FIGURE 4 - REPLACING STANDARD BACK
UPHOLSTERY
PROCEDURE 4 BACK
B
A
C
K