Invacare Top End Terminator Jr. User Manual
Page 30
30
WHEELS
PROCEDURE 7
WARNING
QUICK RELEASE LEVERS - Make sure the quick re-
lease levers are pointing towards the rear of the
wheelchair and are in the CLOSED position BE-
FORE using the wheelchair, otherwise personal
injury or damage to the wheelchair may result.
STANDARD - Make sure the hex screws and lock-
nuts are securely tightened BEFORE using the
wheelchair, otherwise personal injury or damage
to the wheelchair may result.
8. Close the camber clamps. Refer to OPENING/CLOS-
ING CLAMPS in this procedure of the manual.
9. Repeat STEPS 1-8 for opposite side of wheelchair.
10. Reinstall rear wheel to the wheelchair. Refer to RE-
MOVING/INSTALLING REAR WHEELS in this pro-
cedure of the manual.
11. Adjust toe in/toe out of wheelchair. Refer to DETER-
MINING/ADJUSTING TOE IN/TOE OUT in this pro-
cedure of the manual.
W
H
E
E
L
S
ADJUSTING REAR WHEEL CAMBER
(FIGURE 7)
NOTE: Perform this procedure to one (1) side of the wheel-
chair at a time for ease of adjustment.
1. Open the camber clamps. Refer to OPENING/CLOS-
ING CLAMPS in this procedure of the manual.
2. Pull one (1) rear wheel with camber insert out of axle
tube.
3. Remove the rear wheel from the camber insert.
4. Rotate the camber insert 180
o
.
5. Reinstall the rear wheel into the camber insert.
WARNING
NEVER position the camber inserts in the axle tube
with more than 3-inches (12 indexing marks show-
ing) of the camber insert outside of the axle tube.
The camber inserts will not be securely tightened
in the axle tube resulting in possible injury to the
user and/or damage to the wheelchair.
6. Position the camber insert to the desired position. Make
sure there is no more than 3-inches (12 indexing marks)
of the camber inserts outside of the axle tube.
7. Slide the indexing ring on the camber insert until it is
flush with the camber clamp.
NOTE: Before using the wheelchair, make sure both cam-
ber inserts are set to the same indexing mark. This will
make sure the distance between the rear wheel and the
wheelchair is the same on both sides.
CLOSED
POSITION
OPEN
POSITION
Quick
Release
Lever
Locknut
STANDARD
QUICK RELEASE LEVER
Hex
Screw
STANDARD
QUICK RELEASE LEVER
CLOSED POSITION
Quick
Release
Lever
OPEN POSITION
Hex Screw
Locknut
CAMBER CLAMPS
RECEIVER TUBE CLAMPS
FIGURE 6 - OPENING/CLOSING CLAMPS
FIGURE 7 - ADJUSTING REAR WHEEL CAMBER
Camber Insert -
Rotate 180
o
Axle Tube
Camber
Clamp
Indexing Marks
Indexing Ring