IBM NETVISTA X40 6643 - Manual (Page 69)

Code Description Action
178x Hard disk or IDE device failed
1. Go to “Running the IBM Enhanced
Diagnostics program” on page 67,
and follow the instructions for
running the diagnostic program for
the hard disk drive and IDE
devices.
2. If the problem persists, have the
computer serviced.
18xx A PCI adapter has requested an
unavailable resource Go to “Starting and using the
Configuration/Setup Utility program”
on page 31 and follow the instructions
to reconfigure the PCI devices.
1962 No startup device found
1. Go to “Starting and using the
Configuration/Setup Utility
program” on page 31 and follow
the instructions to verify that the
startup sequence is configured
properly.
2. If the problem persists, have the
computer serviced.
2400 Display adapter failed; using
alternate Have the computer serviced.
2462 Video configuration error Have the computer serviced.
5962 IDE CD-ROM configuration error Have the computer serviced.
8601 Pointing device error Have the computer serviced.
8603 Pointing device has been removed
1. Make sure that the pointing device
is properly attached.
2. If the problem persists, have the
computer serviced.
Device troubleshooting charts
You can use the troubleshooting charts in this section to find solutions to
problems that have definite symptoms.
Important
If you find it necessary to remove the computer cover, first read “Safety
notices” on page vii for important safety information and instructions.
Chapter 6. Troubleshooting 53