Interquartz 9859 - Manual (Page 14)

14
sensitivity. The control is located on the underside of the telephone (see fig 1).
The adjustment can be made with a small screwdriver or similar implement that
will fit into the control slot.
To make this adjustment
1. Connect the HEADSET to the socket at the rear of the telephone (see fig 1)
2. Set the HF/HS switch to HS (Headset)
3. With the HEADSET plugged in, put it on and lift the HANDSET to the other
ear and make an out-going call.
4. Using the HANDSFREE / HEADSET key, switch between HANDSET and
HEADSET modes (the indicator will illuminate when the HEADSET is in
use) while speaking to the other party.
5. Determine with the other party if your voice level is the same when using the
HANDSET and HEADSET while swapping from one mode to the other
6. If a difference is deleted, adjust the microphone sensitivity so that your voice
level. When using the HEADSET matches that of the HANDSET.
HANDSFREE MICROPHONE SENSITIVITY ADJUSTMENT
Located on the underside of the telephone (see fig 1), this control allows the
user re adjust their voice level as heard by the person they are speaking to
using a small screwdriver or similar implement that will fit into the control slot,
turn the control clockwise to increase your voice level and anti-clockwise to
decrease your voice level.
LOCATION
The telephone should be placed on a desk, table or shelf where it is not likely
to be pushed off and damaged. Avoid excessive heat, damp, dust, direct
sunlight, vibration, and other appliances or devices which may transmit or emit
electrical or electromagnetic radio frequency raise or signals (eg. computers,
welders, pagers).