Installing – IBM N2800e User Manual
Page 18
Installing the support base
Slide the base
B onto the notched bottom of the thin
client
A until it latches securely.
Connecting your hardware
Read “Safety notices” on page v before continuing.
1.
Connect the devices listed below to the appropriate
ports:
1 USB devices
2 Network cable
3 Serial device 2
4 Serial device 1
5 Parallel devices
6 Monitor
7 Mouse
8 Keyboard
13 Headphones
14 Microphone
2.
Tighten all device cable connections.
3.
Connect the thin client power cable to the power
socket
10 .
4.
Plug all power cables into properly grounded working
electrical outlets.
5.
To power on your thin client, move the power supply
switch
9 to the ″on″ position.
Notes:
a.
The white power switch
11 resets the power to
your thin client.
b.
The system LED
12 should flash from amber to
green. See “Resolving hardware problems” on
page 31 for deviations.
6.
Choose the operating system for your server from the
menu that appears on your screen. Refer to the server
software information to verify the correct selection for
your network.
Note:
If your thin client is unable to receive the
operating system code from the server, contact your
network administrator.
8