IBM N2800e - Manual (Page 21)

Configuring the N2800e Thin Client Express
Before you can use the N2800e Thin Client Express (also referred to as workstation)
to access server applications, you need to configure your workstation. You can use
the NSBoot Setup Utility (also referred to as Setup Utility) and the Thin Client
Express Configuration Tool (or Configuration Tool) to configure workstations.
Note: You do not need access to an external server to set up and configure the
workstation.
This section provides information on the following:
v “Using the Setup Utility to configure the workstation”
v “Using the Configuration Tool to configure the workstation” on page 12
Using the Setup Utility to configure the workstation
The Setup Utility allows you to perform the following tasks:
v Specify your keyboard language settings
v Set the resolution and frequency of your display
v Configure your Internet Protocol (IP) settings
v Perform advanced configurations, such as changing your boot file server settings
The first time you start the workstation, you must use the initial Setup Utility to
configure the workstation. The following menu is an example of a Setup Utility
menu:
Figure 2. Example menu
© Copyright IBM Corp. 2000 11