Intel 1300 - Manual (Page 49)

49
Hardware Configuration and Management
Removing and replacing the cover
To remove the cover
1. Use a Phillips screwdriver to remove the screw from the front edge of the
cover.
2. Grasp the back edge of the cover and simultaneously pull from the back
edge and push near the front until the cover slides out from under the
edge of the server front panel.
3. Grasp the notch in the front center of the cover and lift to remove the
cover.
To replace the cover
1. Position the cover on the chassis with the notched edge facing the front
and the slotted sides of the cover inside the chassis frame.
2. Grasp the back edge of the cover and simultaneously push from the back
and top until the front edge of the cover slides all the way under the edge
of the server front panel.
3. Use a Phillips screwdriver to tighten screw to securely attach the cover to
the chassis.