Intel 1300 User Manual
Page 56
56
Hard disk drive activity indicator does not light
If you've installed one or more hard disk drives in your appliance, check the
following:
•
Are the power and signal cables to the drive properly installed?
•
Are all relevant switches and jumpers on the hard drive and adapter board
set correctly?
•
Is the onboard IDE or SCSI controller enabled?
•
Is the hard disk drive properly configured?
Hard disk drive activity
The hard disk drive activity light on the front panel lights when either an IDE hard
disk drive, or a SCSI device, is in use. This LED does not display CD-ROM
activity.
Cannot connect to a appliance
Check the following:
•
Make sure the network cable is securely attached to the connector at the
back panel and that the network controller Link LED is on (visible at back
panel). If the cable is attached but the problem persists, try a different
cable.
•
Make sure the network cable is connected to the Adapter 1 port (the lower
of the two ports) on the back of the appliance.
Problems with network
The appliance hangs when the drivers are loaded:
•
Contact technical support.
If diagnostics pass, but the connection fails:
•
Make sure the network cable is securely attached.
•
Make sure the network cable is connected to Adapter 1 (the lower of the
two connections) on the back of the appliance.
•
Check the network configuration files.
•
Using the LCD Network menu, make sure the appliance has a network
address.