Interquartz 98583 - Manual (Page 18)

17
5. PABX and System Usage
This telephone can be used behind a PABX or on a network system that
utilises the recall function. There are many such systems and whilst it is
likely that no problems will be encountered, it cannot be guaranteed that the
telephone will operate correctly under all circumstances and any cases of
difficulty should be referred to your supplier.
Recall
This telephone is supplied set to Timed Break Recall. If your system has an
Earth Recall, the PBX recall switch will need to be reset.
Before you attempt to change the recall switch ( see Figure 1 ), you should
disconnect the phone from the network, if you have so connected it.
You will need a small screwdriver, or similar pointed tool, to remove the clear
plastic cover plate and the single touch memory location card. With the tool
you can then adjust the switch to the setting required.
If you are unsure as to which recall setting is applicable, please consult your
PABX manager or supplier.
Note : there are some other switches beneath this cover. Do NOT adjust
them as they will affect the memory operation of the telephone.
Replace the covers, plug the phone back into the socket and it is ready for
use.
PABX access
Where a PABX access digit is required to obtain a direct outside line, it may
be necessary to insert a pause after dialling the access digit, but ( see also
Section 3 ).