IBM SUREMARK TI8 - Manual (Page 133)

Table 15. EIA-232 commands in alphabetical order (continued)
Description Command Page
Set print mode ESC ! n or X'1B21;n' 129
Set print station parameters ESC c 1 n or X'1B63;31;n' 136
Set print station ESC c 0 n or X'1B63;30;n' 134
Set printing position GS ] x y or X'1D;5D;x;y' 180
Set relative horizontal position ESC <5C>h n1 n2 or X'1B;5C;n1;n2' 180
Set relative position ESC \ n1 n2 or X'1B5C;n1;n2' 139
Set relative vertical position GS \ y or X'1D;5C;y' 179
Set sheet eject length ESC C n or X'1B43;n' 138
Set vertical position GS $ y or X'1D;24;y' 178
Start scan X'1B;3E;n' 166
Status request ESC v or X'1B76' 112
Status sent to system ESC ) n or X'1B29;n' 141
Store scanned image X’1B;41;n1;x0;y0;dx0;dy0;x1;y1;dx1;dy1;x2;y2;
dx2;dy2;x3;y3;dx3;dy3;tagdata’ 169
Tab to next tab stop HT or X'09' 160
Thermal code page MCT commands; see Table 17 on page 125. 119
Verify previous commands
completed X'1B;00;80;00' 111
System commands
Exercise program
EIA-232 Syntax:
ESC x or X'1B;78'
Purpose:
This tests printing functions of the printer. A test message is printed. (See
Figure 36 on page 64.) If there is a document in the printer, the test
message prints on the document. Otherwise, it prints at the customer
receipt station.
Error Conditions:
Home Error (on document station only)
Cash Receipt Print Error
Verify previous commands completed
EIA-232 Syntax:
X'1B;00;80;00'
Purpose:
This command can be used to ensure that all commands preceding it have
been completed. The application would just wait for the status return with
status byte 5, bit 1 set.
Updated April 2, 2009
Appendix D. EIA-232 programming information 111