Connecting your monitor – Iiyama MA203DT D User Manual
Page 10
ENGLISH
Ensure that both the computer and the monitor are switched off.
CONNECTING YOUR MONITOR
A
B Connect the computer to the monitor with the signal cable. (See page 17 for CONNECTOR
PIN ASSIGNMENT.)
C Connect the Power Cable to the monitor first and then to the power supply.
The signal cables used for the connection vary by the type of computers you use. An
incorrect connection may cause serious damage to both the monitor and the computer.
The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a
special cable is required please contact your local iiyama dealer or regional iiyama
office.
Make sure you tighten the finger screws at each end of the signal cable.
n
n
NOTE
For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
n
7 BEFORE YOU OPERATE THE MONITOR