Integra DTR-7.2 - Manual (Page 26)

26
• The DTR-7.2 is shipped with the main power (Power) switch in
the on position ( ON ). When the power cord is plugged in for
the first time, the DTR-7.2 will automatically enter the standby
state and the Standby indicator will light (same condition after
step 2 below).
• Before you plug in the DTR-7.2, confirm that all connections
have been made properly.
• Turning on the power may cause a momentary power surge,
which might interfere with other electrical equipment on the
same circuit, such as computers. If this happens, use a wall outlet
on a different circuit.
1. Plug the power cord into an AC wall outlet.
2. Press the ON button to turn on the
DTR-7.2 (take it out of the standby
state).
To return the DTR-7.2 to the standby state,
press the STDBY button.
Turning the power on from the remote controller:
Before you can use the remote controller, you must perform steps 1
and 2 above and place the DTR-7.2 in the standby state.
1. Press the RCVR MODE button.
The RCVR MODE button lights green.
Memory preservation
This unit does not require memory preservation batteries. A built-
in memory power backup system preserves the contents of the
memory during power failures and even when the Power switch
is set to off. The Power switch must be set to on in order to charge
the backup system.
The memory preservation period after the unit has been turned off
varies depending on climate and placement of the unit. On the
average, memory contents are protected over a period of a few
weeks after the last time the unit has been turned off. This period
is shorter when the unit is exposed to a highly humid climate.
3. Press the Standby/On button to turn
on the DTR-7.2. The display and four
jog dial indicators will light up and
the Standby indicator will turn off.
If you press the Standby/On button again,
the receiver returns to Standby mode.
2. Press the Power switch to set the
DTR-7.2 to standby state.
The Standby indicator will light up.
To change the display of the input source from TAPE to
MD:
If you connected an MD recorder to the TAPE jack on the DTR-7.2,
you can have “MD” appear when the Tape source button is pressed.
By changing the display, if an Onkyo MD recorder z-connected,
the z system functions will become enabled.
Changing the display:
Press and hold down the Tape source button until the display
changes from TAPE to MD (approx. 3 seconds).
To return the display to its original setting, perform the same
procedure. This setting is necessary to allow z system functions
for the connected cassette tape or MD recorder.
Connecting the power
Turn off
HOME THEATER CONTROLLER RC-461M
Master Volume Standby/On
Power
On O f f
psampling U
Audio Selector Tape FM AM Phono CD
Digital
Video 1
VCR 1
Video 3 Video 2
VCR 2
Video 4 Video 5 DVD Zone 2 ( ) GRN Rec ( ) RED
A-FO RM Listening Mode Memory
Video 5 / Video Cam Input
Stereo Direct DSP Surround THX
Clear
FM Mode Memory
Rec Out Zone 2 Of f Dimmer Display
S Video Audio Video L R
Phones
Standby
Enter
Return
Se tup
Preset
Tun ing
Power
Tape
Standby/On
Standby indicator
To wall outlet
ON
RCVR
STDBY
Standby/On
Standby
Power
On O f f
Standby
Tape