Integra DTR-7.2 - Manual (Page 53)

53
Changing the audio mode
Press the Audio Selector button on the front panel (or AUDIO button
on the remote controller) to change the audio mode. Each time the
button is pressed, the mode changes from “Auto”
→ “Multich” →
“Analog” and back to “Auto.” The “Auto” audio mode is
recommended for normal circumstances.
Enjoying music or videos with the DTR-7.2
Auto (automatic detection): With this setting, the DTR-7.2
automatically detects whether the input signal is digital or analog.
When a digital signal is not input, then the analog signal is played.
Multich (Multichannel): Select this setting to play back the input
from the component connected to the MULTI CHANNEL INPUT
port. This setting is effective when the Multichannel setting in the
Multichannel sub-menu is set to “Yes” (see page 35).
Analog: Select this setting to play back the input from a source
component connected to an analog audio input jacks. With this
setting, even if a digital signal is input from the same component,
only the analog signal will be output.
3. Turn on the connected component and start playing
the desired media.
4. If necessary, adjust the output level of each speaker
as desired (see page 52).
Adjust the speaker output levels so that you can hear the same
sound level from each speaker at the listening position. For the
front right, front left, center, surround right, and surround left
speakers, the output levels can be adjusted between –12 to +12
decibels. The subwoofer can be adjusted between –30 to +12
decibels.
5. Adjust the volume with the Master Volume dial or the
VOL buttons on the remote controller.
DTR-7.2 Remote controller
DTR-7.2 Remote controller
DTR-7.2 Remote controller
Enjoying the multichannel output
Before starting operations, first make sure that the multichannel
connection is properly made and that the Multichannel setting of the
Input Setup
→ Multichannel Setup sub-menu to “Yes.”
1. Press the input source button for the component with
multichannel output connected to the MULTI
CHANNEL INPUT on the rear of the DTR-7.2.
2. Select “Multich” using the Audio Selector button on
the front panel (AUDIO button on the remote
controller).
Using the tone control:
Each time you press the DIRECT button on the remote controller,
the display changes from “Direct”
→“Tone On.” To make bass and
treble adjustment work for multichannel sources, you must first set
the tone control to “Tone On.”
1. Press the Direct button (or DIRECT button on the
remote controller) to display “Tone On.”
When pressed only once, the current setting appears, so press
twice to change the setting.
2. Adjust the tone at the Setup menu: Audio Adjust
→
Tone Control.
Note:
Adjusting the volume level of each speaker for the MULTI CH
INPUT source does not affect the speaker level adjusted by the
listening position.
DTR-7.2 Remote controller
HOME THEATER CONTROLLER RC-461M
Master Volume Standby/On
Power
On O f f
psampling U
Audio Selector Tape FM AM Phono CD
Digital
Video 1
VCR 1
Video 3 Video 2
VCR 2
Video 4 Video 5 DVD Zone 2 ( ) GRN Rec ( ) RED
A-FO RM Listening Mode Memory
Video 5 / Video Cam Input
Stereo Direct DSP Surround THX
Clear
FM Mode Memory
Rec Out Zone 2 Of f Dimmer Display
S Video Audio Video L R
Phones
Standby
Enter
Return
Se tup
Preset
Tun ing
Audio Selector Input source buttons
DIRECT
AUDIO
Master Volume Direct
VOL
Audio
Selector
Audio
Selector
Master Volume
Direct