IBM 16/4 Token-Ring - Manual (Page 26)

Note: For some drivers, a message might appear indicating that the driver
must be loaded manually (at the console prompt). To load a driver
manually, follow the screen prompts or press F1 for more information.
6. Set protocols. When the window containing protocol choices is displayed,
select the protocol that you want to use and press the space bar. If you select
TCP/IP, enter the IP address and the IP mask.
7. Set parameters. Use the down arrow key to move the cursor to the parameter
window. Enter parameter values as needed. Press F1 for help.
It is recommended for servers that the Data Rate be set to 4 Mbps or 16
Mbps, and clients be set to Automatic.
In some cases, the system displays a pop-up list of values for the field from
which you select the desired value. In other cases, you must type in a value
and press Enter to move to the next field.
8. To specify a particular frame type for a token-ring driver, press F3 to display a
list of frame types. Use the arrow keys to move up and down the list.
9. Press Enter to select a frame type.
10. When finished, press F10.
If you do not specify a particular frame type, all frame types are loaded
automatically, but only those found on the network are actually bound to the
driver.
11. Select Save parameters and load driver.
12. Confirm bindings of the protocol with the driver and the network number.
13. To add another adapter, shut down the server, power off the server, and insert
the additional driver. NetWare will load the appropriate driver automatically.
Then repeat step 12.
Novell Client DOS/Windows 3.1x
1. Download Novell Client DOS/Windows 3.1x Version 2.5 or later from Novell’s
Web site at
http://support.novell.com.
2. Unzip the downloaded file to a directory on your computer.
3. Exit Windows.
4. From a DOS prompt, go to the directory where you put the file. Run
INSTALL.EXE.
5. Select Yes or No to respond to the Novell License Agreement.
6. Select Novell Client Windows Support and Work Station Manager 3.X.
Press F10 to save and continue.
7. Select 32-bit LAN Drivers and press F10 to save and continue.
8. Select USER SPECIFIED 32-Bit Driver and press Enter.
9. Insert the CD-ROM or the diskette containing the device drivers into the
appropriate drive. Enter the path to the 32-bit ODI driver: x:\novell\netware
where x is your CD-ROM drive letter. The panel should say
IBM Token-Ring PCI Family Adapter
Press Enter, configure the parameters, and press F10 to save and continue.
10. At the panel entitled Installation Configuration Summary, confirm that the
values are what you selected, and press F10 to save and continue.
The files will be copied at this point.
11. Reboot the computer and start Windows to connect to and log in to your
server.
18 IBM 16/4 Token-Ring PCI Management Adapter