Intel 537EX - Manual (Page 18)

18 536EX Chipset Developer’s Manual
Intel Confidential
AT Command Summary Tables
* -Cn Generate data mode calling tone 0 0–2 no
-C0 Calling tone disabled
-C1 1300 Hz calling tone enabled
-C2 V.8 calling tone and 1300 Hz calling tone
+A8E=m V.8 and V.8 bis operation controls
1, 1, C1,
0, 0
See note no
+EB Controls break handling 1, 0, 30 See note no
+ESA Synchronous access mode configuration
0, 0, 1, ,
0, 0, 0,
no
+ESR Controls selective repeat option in V.42 1 0–2 no
+ETBM Controls call termination buffer management 1, 1, 20 See note no
+GCAP Request complete capabilities list none no
+GCI Country of installation none no
+GMI Identify modem manufacturer none – no
+GMM Identify product model none – no
+GMR Identify firmware version none – no
+GSN Identify product serial number ID none – no
+IFC Controls DTE-DCE flow control 2, 2 See note no
+ILRR=m Controls local rate reporting 0 0, 1 no
m=0 Disabled
m=1 Enabled
+MA Controls modulation automode – See note no
+MR=m Selects modulation 0 See note no
m=0 Disabled
m=1 Enabled
+MS=m Modulation selections
V92, 1,
0, 0, 0, 0
See note a no
+PCW=m Call waiting enable 0 no
+PHSW=m Controls 2C relay none 0, 1 no
+PIG=m PCM upstream ignore 1 no
+PMH=m Modem on hold enable 0 no
+PMHF V.92 modem on hold hook flash none no
+PMHR Initiate modem on hold none no
+PMHT=m Modem on hold timer 0 no
+PQC=m V.92 phase 1 and phase 2 control 0 no
+PSS=m Use short sequence 2 no
Table 5. Data Mode Command Summary (Continued)
Note Command Function Default Range
Reported
by &Vn
* Value saved in NVRAM.
** Command not preceded by an ‘AT.’