Getting started, How to make your player stand, First time to use the remote control – Iluv i1055 User Manual
Page 13: Remote control battery installation, Using the ac adapter
PORTABLE DVD PLAYER V10M10_IM_EN_09182006
How to Make Your Player Stand
Follow the illustrations below to make your player stand.
Pull out the STAND at the back of the unit gently. Then, carefully stand the unit.
First time to Use the Remote Control
The battery is pre-installed in the remote control with the insulation plate. Before starting to
operate the remote control, please pull out the insulation plate from the battery compartment.
Remote Control Battery Installation
If the remote control does not work or the signal gets weaker, the
battery might weaken. In that case, please replace the battery.
Pull out the battery holder as shown right.
Place one battery (CR 2025) as shown right. Make sure that
the polarity (+/–) of battery matches the marks inside the unit.
Insert the battery holder into its compartment as shown right.
Do not attempt to recharge, short-circuit, disassemble, heat or throw the batteries into a
Using the AC Adapter
Insert the DC plug at the end of the adapter cord into
the DC IN jack at the top side of the player.
Plug the other end into an AC wall outlet.
Only use with the supplied AC adapter. Using with
another AC adapter could cause damage. Remove both the
DC plug and AC plug to disconnect the AC adapter when not necessary.