Integra DTR-5.2 - Manual (Page 26)

26
Using the sleep time (Remote controller only)
The SLEEP button enables you to set the DTR-5.2 to turn off
automatically after a specified time period. If you press it once, the
DTR-5.2 will turn off after 90 minutes. Each time it is pressed
thereafter, the remaining time until the DTR-5.2 turns off decreases
by 10 minutes. While, the sleep function is enabled, you can press
the SLEEP button to see how much time is left. To cancel the sleep
function, press the SLEEP button when the time displayed is less
than 10 minutes.
Standby/On
Standby
Power
On O f f
Phones DVD Video 2 Video 1 Video 3 Bass Treble
Master Volume
Smart Scan Navigator Dimmer Display Tuning FM Mode Preset Memory Preset
VCR
Audio Selector Tape FM AM Phono CD
Push To Enter
DSP/ Mode ADJ Setup
Return
CH Level A B Speakers
HOME THEATER CONTROLLER RC-441M
Master Volume
RCVR
MODE
CH SEL
SLEEP
AUDIO
DISPLAY
MUTING
Speakers A/B
Display
CH Level
Treble Bass
Audio Selector
SP A, B
VOL
LEVEL
Enjoying music or videos with the DTR-5.2
Selecting speakers (Speakers A, B)
Speakers A: This button turns on or off the speakers connected to
the FRONT SPEAKERS, CENTER SPEAKER, SURROUND
SPEAKERS, and SUBWOOFER terminals.
When you listen to surround audio or select multi channel input, be
sure to turn on Speakers A.
When the speakers are turned on, the SPEAKERS A indicator lights
up.
Speakers B: This button turns on or off the speakers connected to
the FRONT SPEAKERS B terminals.
When the speakers are turned on, the SPEAKERS B indicator lights
up.
Notes:
• You cannot select surround sound when you are using Speakers
B.
• When using the B speakers, the A speakers can only be used for
stereo or direct playback, so nothing will be output from the left
and right surround speakers during multichannel playback.
Adjusting the volume
Adjusting the main volume adjusts the volume level output from all
the speakers connected to the DTR-5.2 together. If headphones are
connected, this also adjusts the volume heard from the headphone
speakers. To adjust the volume, either press the VOL
buttons on
the remote controller or turn the Master Volume dial. To increase the
volume, turn the dial clockwise; to decrease the volume, turn the dial
counterclockwise. The volume can be set to Min, 1 to 79, and Max.
Adjusting the bass and treble
You can adjust the bass and treble levels using the Bass and Treble
dials. This function only affects the front left and right speakers. For
multichannel sources, these dials will not work if the tone control is
set to “OFF.” (Refer to page 27.)
Temporarily turning off the sound (Remote
controller only)
To turn off the sound momentarily, such as when interrupted by a
phone call, press the MUTING button on the remote controller.
When pressed, “MUTING” is displayed on the DTR-5.2. Press the
MUTING button again to turn the sound back on.
Jog dial
Switching the display
While listening to or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the DISPLAY button on the DTR-5.2 or the remote
controller.
When an input source other than FM or AM is selected:
Input + volume
Program format*
Input +
Listening mode
or MULTI CH
* If the input signal does not have a program format, then this will
be skipped.
When FM or AM is selected as the input source:
FM/AM frequency +
Preset no.
FM/AM +
Listening mode
ch