Intellinet Network Solutions 550000 - Manual (Page 20)

Network Video Server User’s Guide
20
Assigning IP Address
Follow these steps to assign an IP address using Hyper Terminal
1. Execute “Hyper Terminal” on your PC
2. Connect RS232 Cable to the serial port of PC that you have selected in Chapter 4.3.1 -
Configuring Hyper Terminal and the NETWORK VIDEO SERVER serial port while Hyper
Terminal is executed.
3. Supply power to the NETWORK VIDEO SERVER.
4. A count down will start with the message “Press any key to stop auto-boot.”
5. Press any key and then “Boot” Prompt shall appear as below.