Switching input signal – InFocus IN100 User Manual
Page 24
Operation
24
your retry. You can press
MENU/EXIT to cancel the change or try
another password.
Though the password function is disabled, you need to keep the old password on hand should
you ever need to re-activate the password function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the same time. However, it
can only display one full screen at a time.
Be sure the
Quick Auto Search function in the SOURCE menu is On (which is the
default of this projector) if you want the projector to automatically search for the
signals.
You can also manually cycle through the
available input signals.
1.
Press
SOURCE on the projector or remote
control. A source selection bar displays.
2.
Press
/
until your desired signal is
selected and press
MODE/ENTER.
Once detected, the selected source
information will display on the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-
2 to search for another signal.
•
The brightness level of the projected image will
change accordingly when you switch between
different input signals. Data (graphic) "PC"
presentations using mostly static images are
generally brighter than "video" using mostly
moving images (movies).
•
The input signal type affects the options available for the Preset Mode. See
for details.
•
The native display resolution of this projector is in a 4:3 aspect ratio. For best display
picture results, you should select and use an input signal which outputs at this resolution.
Any other resolutions will be scaled by the projector depending upon the 'aspect ratio'
setting, which may cause some image distortion or loss of picture clarity. See
for details.
/
O
G
O
L
e
m
a
N
l
e
d
o
M
a
e
r
A
35.
0m
m
m
m
0
.
5
4