Personalizing the projector menu display, Shutting down the projector – InFocus IN100 User Manual
Page 36
Operation
36
Adjusting the sound level
To adjust the sound level:
1.
Repeat steps 1-2 above.
1.
Press
to
highlight
Volume and press / to select a desired sound level.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences.
The following settings do not affect the projection settings, operation, or
performance.
•
Menu display time in the SYSTEM SETUP: Advanced > Menu Settings
menu sets the length of time the OSD will remain active after your last key
press. The time length ranges from 5 to 30 seconds in 5-second increments.
Use
/
to select a suitable time frame.
•
Menu position in the SYSTEM SETUP: Advanced > Menu Settings menu
sets the OSD position in five locations. Use
/
to select a preferred position.
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for
the OSD menus. Use
/
to select your language.
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo
screen to be displayed during projector start-up. Use
/
to select a screen.
Shutting down the projector
1.
Press
POWER and a confirmation
message displays prompting you.
If you don't respond in a few seconds, the
message will disappear.
2.
Press
POWER a second time. The
POWER indicator light flashes orange,
the projection lamp shuts down, and the
fans will continue to run for approximately
90 seconds to cool down the projector.
3.
The
POWER indicator light is a steady
orange and fans stop.
4.
Disconnect the power cord from the wall
socket if the projector will not be used for
an extended period of time.
CAUTION
•
To protect the lamp, the projector will not respond to any commands during the cooling
process.
•
To shorten the cooling time, you can also activate the Quick Cooling function. See
for details.
•
Do not unplug the power cord before the projector shutdown sequence is complete or
during the 90-second cooling down process.
•
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press POWER again to
start the projector after the fans stop and the POWER indicator light turns orange.
I
I
I
I
I
I