ISEKI CISCO SYSTEMS OL-5450-10 - Manual (Page 47)

47
Release Notes for VPN Client, Release 4.0 through Release 4.0.5.D
OL-5450-10
Open Caveats
• CSCdx51632
If the computer is powered off or loses power during an MSI installation of
the VPN Client, the VPN Client may not be registered in Control Panel, and
the following may occur when attempting to reinstall:
– A message may appear stating:
Deterministic Network Enhancer Add Plugin Failed
Click the “OK” button.
– Error 1722. There is a problem with this Windows Installer package. A
program as part of the setup did not finish as expected. Contact your
Support personnel or package vendor. Click the “OK” button.
– Error 1101. Error reading from file c:\config.msi\laff4.rbs. Verify that the
file exits and you can access it. Click the “OK” button.
– Error 1712. One or more of the files required to restore your computer to
its previous state could not be found. Restoration is not possible. Click
the “OK” button.
After clearing the last message box, restart MSI installation. It should
successfully install the VPN Client.
• CSCdx57197
If IOS sends a split tunnel attribute that is host-based (255.255.255.255
mask), the VPN Client uses the host in a QM, but it passes the
IPV4_ADDR_SUBNET in the ID payload.
IOS expects IPV4_ADDR, as this is a host ID. This causes connectivity
issues.
• CSCdx70223
The VPN Client’s xauth dialog always stays in the foreground so it doesn't
get “lost” (on XP it goes to the background and then jumps forward within
seconds). The xauth dialog does not have focus, however, and it can be
difficult to enter the username/password without first clicking on it with the
mouse. This was observed on Windows 2000 and Windows XP; we have not
checked Windows 98.
• CSCdx72463
Installing the VPN Client using the Microsoft Windows Installer (MSI)
displays “Time Remaining” for the installation. This time is not very accurate
and should be ignored.