iOptron SmartStar MiniTower Pro - Manual (Page 8)

8
2. MiniTower Pro
TM
Assembly
There are two shipping boxes. One box contains the hard case and mount components. The
other box contains the tripod and counterweight.
2.1. MiniTower Pro Assembly
Figure 5
1 . Setup tripod. Extend tripod legs to full extension. Then lock
legs using the lock knobs on sides.
Next expand the legs out to their maximum position.
Figure 6
2 . Assemble the three prong washer and azimuth clutch lock
(#11) onto the mount base
Figure 7
3 . Carefully position telescope mount onto the tripod by aligning
the three holes on the bottom of the mount base (#8) to the
three level adjustment screws (#6) on the top of the tripod (#7),
hold the mount with your hands.
Adjust level adjustment screws (#6) to level the mount using the
bubble level on the base.
#11
Washer
#6