Integra CDC-3.4 - Manual (Page 14)

14
Turning On the CDC-3.4
Before connecting the power cord and turning on the
CDC-3.4, connect all your AV components first (see
page 11).
Don’t forget to turn on your amp, and select the audio
input to which the CDC-3.4 is connected.
Note:
• You can turn on the CDC-3.4 and simultaneously open
the disc tray or start playback simply by pressing the
Open/Close [
] button or the Play [ ] button respec-
tively. The CDC-3.4 will take a little longer to come
on.
Basic Playback
Notes:
• The CDC-3.4 supports 8 cm and 12 cm discs. To avoid
damaging your discs or CDC-3.4, be sure to put discs
in the centers of the disc bays.
• Only load discs that are supported by the CDC-3.4
(see page 26).
• To avoid personal injury, keep your hands away from
the disc tray as it closes.
• Always use the Open/Close button to open and close
the disc tray. Never push the disc tray, and don’t touch
or obstruct it while it’s opening or closing. Don’t press
down on the disc tray while it’s open. Doing so may
damage your discs or CDC-3.4.
Turning On the CDC-3.4
1 Plug the supplied power cord into
the AC INLET. Then plug the other
end to a suitable wall outlet.
The standby indicator light up.
• Do not use a power cord other than the
one supplied with the CDC-3.4. The
power cord supplied is designed for
use with the CDC-3.4 and should not
be used with any other device.
• Never have the power cord discon-
nected from the CDC-3.4 while the
other end is plugged into the wall out-
let. Doing so may cause an electric
shock. Always connect by plugging
into the wall outlet last and disconnect
by unplugging from the wall outlet
first.
2 Press the [Standby/On] button, or
the remote controller’s [On]
button.
The CDC-3.4 comes on, the display
lights up, the disc tray light comes on,
and the Standby indicator goes off.
When the CDC-3.4 is turned on, it
checks the carousel for discs and selects
the first disc that it finds.
To set the CDC-3.4 to Standby, press the
[Standby/On] button or the remote con-
troller’s [Standby] button.
Dimmer Display
Standby/On
Standby
Play/Pause Stop Disc Skip
Open /Close
Repeat Random
Folder Folder
Disc Select 1 2 3 4 5 6 Direct Digital Path
Standby/On
AC INLET
Standby/On
Standby
Loading Discs
1 To open the disc tray, press the
Open/Close button.
Put a disc, label-side up, into
each disc bay.
2 To access the other disc bays,
use the [Disc Skip] button or the
remote controller’s Disc [+] and
[–] buttons.
3 To close the disc tray, press the
Open/Close button again.
A circle appears around the number of
the current disc.
Dimmer Display
Standby/On
Standby
Play/Pause Stop Disc Skip
Open /Close
Repeat Random
Folder Folder
Disc Select 1 2 3 4 5 6 Direct Digital Path
Disc Skip
Play/Pause Open/Close Dimmer
Open /Close
Current disc
Disc Skip
Open /Close
3
6
2
5
1
4
AIN