Integra CDC-3.4 - Manual (Page 8)

8
Controls & Connectors —Continued
For detailed information, refer to the pages in parenthe-
sis.
A ANALOG AUDIO OUTPUT (11, 12)
These RCA/phono connectors can be connected to
the analog audio inputs on a hi-fi amp or AV
receiver.
B COAXIAL & OPTICAL DIGITAL AUDIO
OUTPUT (11)
These connectors can be used to connect a CD-R,
MiniDisc, DAT recorder, digital amp, or other
equipment with digital inputs.
C REMOTE CONTROL (11, 12)
These (Remote Interactive) connectors can be
connected to the connectors on your other Inte-
gra/Onkyo AV components for interactive control.
To use
you must also make analog audio con-
nections (RCA/phono) between the CDC-3.4 and
your other Integra/Onkyo equipment.
D AC INLET (14)
The supplied power cord is connected here. The
other end of the power cord should be connected to
a suitable wall outlet.
E RS 232
This RS-232 port can be connected to an external
controller.
F IR IN/OUT (13)
The IR IN connector can be used to connect a com-
mercially available IR receiver, which can be used
to pickup signals from the remote controller when
the CDC-3.4 is located in another room, installed in
a rack, or is out of range of the remote controller.
The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
used to pass remote controller signals received by
the IR IN along to other AV components.
Rear Panel
IR
OUT
IN
MODEL NO. CDC- 3.4
2-1, NISSHIN-CHO, NEYAGAWA-SHI, OSAKA,
JAPAN MADE IN CHINA
COMPACT DISC CHANGER
Integra Division of
ONKYO CORPORATION
RATING:
AC 120 V 60 Hz 10 W
RS 232
AC INLET
1 2 3
5 6 4