Integra CDC-3.4 - Manual (Page 15)

15
Basic Playback —Continued
Notes:
• When you close the disc tray, the current disc will be
the one in the front-right disc bay. When you open the
disc tray, the last disc you selected (i.e., the current
disc), will be in the front-right disc bay.
• When the disc tray is closed, all of the disc indicators
appear until the CDC-3.4 has checked each bay for the
presence of a disc. If a bay is found to have no disc, the
corresponding indicator disappears.
The section explains how to select discs.
This section explains how to load discs without stopping
playback.
Note:
• The CDC-3.4 cannot play the next disc while the disc
tray is open. Be sure to close the disc tray as soon as
you’ve finish loading discs.
You can adjust the brightness of the display as follows.
Starting Playback
To start playback, press the Play/
Pause button.
Playback starts from the first track on
the current disc, continues with the sub-
sequent discs, and stops when disc #6
has been played.
Empty disc bays are skipped.
Tip: If you press one of the Disc Select
buttons, playback of the selected disc
will start automatically.
Selecting Discs
When playback is stopped
Use the Disc Select buttons to select a
disc. Playback will start automatically.
Or, use the [Disc Skip] button or the
remote controller’s Disc [+] and [–]
buttons to select a disc. In this case
you’ll need to press the Play [
] button
to start playback.
During playback
Use the Disc Select buttons, [Disc
Skip] button, or the remote controller’s
Disc [+] and [–] buttons to select a disc.
The current disc will stop playing, and
the newly selected disc will be played.
On the display, the number of the cur-
rent disc has a circle around it.
Play/Pause
TRACK DISC 3
6
2
5
1
4
REMAIN
Disc Skip
Disc 1 Disc 2 Disc 3
Disc 4 Disc 5 Disc 6
Play/Pause
Remote
controller
Loading Discs During Playback
1 To open the disc tray, press the
Open/Close button.
The disc that’s currently playing
remains inside the CDC-3.4 and its disc
bay is empty and won’t come to the
front.
2 Load or remove your discs, and
use the [Disc Skip] button or the
remote controller’s Disc [+] and
[–] buttons to access the other
disc bays.
3 To close the disc tray, press the
Open/Close button again.
Playback of the current disc continues
uninterrupted until you stop playback
or select another disc.
Tip: If you press one of the Disc Select
buttons, the disc tray will close, and
playback of the newly selected disc will
start automatically.
Adjusting the Display Brightness
Press the [Dimmer] button
repeatedly to cycle through the
following options: normal, dim,
dimmer, dimmer with disc tray
light off.
Open /Close
Disc Skip
Open /Close
Dimmer