IBM CP-X445 - Manual (Page 24)

24
Multifunctional settings
EASY Menu
Item Description
ASPECT
Using the buttons ◄/► switches the mode for aspect ratio.
See the item ASPECT of section IMAGE menu (29).
MODE
Using the buttons ◄/► switches the mode of picture type. The
modes of picture type are combinations of a mode of GAMMA and
a mode of COLOR TEMP. Choose a suitable mode according to the
projected source.
NORMAL  CINEMA  DYNAMIC
NORMAL: (COLOR TEMP = MIDDLE) + (GAMMA = #1 DEFAULT)
CINEMA: (COLOR TEMP = LOW) + (GAMMA = #2 DEFAULT)
DYNAMIC: (COLOR TEMP = HIGH) + (GAMMA = #3 DEFAULT)
• When the combination of GAMMA and COLOR TEMP differs
from pre-assigned modes above, the display on the menu for the
MODE is “CUSTOM”. Please refer to the items GAMMA (26) and
COLOR TEMP (27) of PICTURE menu.
• When this function is performed, a certain extra such as a line
may appear.
BRIGHT
Using the buttons ◄/► adjusts the brightness.
See the item BRIGHT of section PICTURE menu (26).
CONTRAST
Using the buttons ◄/► adjusts the contrast.
See the item CONTRAST of section PICTURE menu (26).
COLOR
Using the buttons ◄/► adjusts the strength of whole color.
See the item COLOR of section PICTURE menu (27).
TINT
Using the buttons ◄/► adjusts the tint.
See the item TINT of section PICTURE menu (27).
SHRPNESS
Using the buttons ◄/► adjusts the sharpness.
See the item SHARPNESS of section PICTURE menu (27).
WHISPER
Using the buttons ◄/► turns off/on the whisper mode.
See the item WHISPER of section SETUP menu (34).
With the EASY MENU, items shown in the table below can
be performed.
Select an item using the cursor buttons ▲/▼ on the
projector or remote control. Then perform it referring to the
following table.
EASY MENU
CONTRAST
ASPECT 4:3
BRIGHT
MODE NORMAL
COLOR
+0
+0
+0
TINT +0
SHARPNESS +3
WHISPER NORMAL
RESET
FILTER TIME 0
LANGUAGE ENGLISH
Go To Advance Menu...
MIRROR NORMAL