Jwin JX-CD561 - Manual (Page 16)

Portable AM/FM Radio and CD Player V10M10_IM_EN_12262006
www.jWIN.com - 14 -
OPERATIONAL INSTRUCTIONS
Listening to the Radio
Slide the FUNCTION SWITCH to the “RADIO” position. Slide the
BAND SWITCH to the desired waveband. Turn the TUNING KNOB to
your desired radio station. Adjust the sound level by rotating the
VOLUME CONTROL KNOB. To turn off the radio, simply slide the
FUNCTION SWITCH to “OFF” position.
Note: Radio frequency is shown on the LCD DISPLAY.
FM Stereo Indication
When tuned to a FM Stereo broadcast, the FM stereo
indication will be shown on the LCD. In weak signal
areas the FM stereo signal may not be strong enough
and can cause excessive background noise. In this
case, slide the BAND SWITCH to the “FM” position.
Antennas
For best reception, fully extend the FM TELESCOPIC ANTENNA to receive FM stations. For
AM reception, the unit has a built-in antenna, turn the whole unit for best reception.
Auxiliary (AUX) Mode
1. Slide the FUNCTION SWITCH to the “AUX” position.
2.
Connect the earphone socket from the auxiliary unit (e.g.
MP3 player or MD player) into AUX-IN jack on the rear of
this product via an audio patch cable (3.5mm plug on
both ends).
3.
Play the auxiliary unit. Music from the auxiliary unit can be listened to through the speaker
of this product.
Stereo Headphone Jack
For private listening, insert the plug of a stereo headphone
into the STEREO HEADPHONE JACK and adjust the
VOLUME CONTROL KNOB accordingly. During the use of a
headphone, the speakers are automatically disconnected.
Bass Boost
For increased bass at all volume levels, push the BASS
BOOST BUTTON to the “ON” position to boost the low
frequency tone for an emphasized bass sound. To
release the super bass, simply push the button again.