JVC TK-C215VP4U/E - Manual (Page 19)

19
Follow the procedures below to connect/set this
unit.
Turn off the power of devices to be used before
connecting the cables.
K
K
K
K
K
K
The right sequence to
connect and set the camera
ⅷ Before touching the camera unit, make
sure to touch the metal surface of the
[MONITOR] terminal to discharge any
static electricity from your body. Static
electricity may cause the camera to
malfunction.
ⅷ When mounting the base to the ceiling, or
when connecting the cable of the camera
unit, pay enough attention to the fall of
each part.
ⅷ When mounting the heater (sold
separately: KA-ZH215), read the
instruction manual of the heater carefully
before mounting.
step 1
Set the switches
(
A Pg. 20)
Remove the dome cover, followed
by setting the video image
switches.
step 2
Mounting the base
(
A Pg. 21)
Mount the base to the wall or
ceiling.
step 3
Connect the cable
(
A Pg. 22)
Connect the coaxial cable and
power supply for the heater.
step 4
Mounting the camera unit
(
A Pg. 23)
Fill the piping hole and screw hole
with a sealing material, followed
by mounting the camera unit to
the base.
step 5
Adjusting the video image
(
A Pg. 25)
Adjust the camera’s angle, focus
and brightness.
step 6
Mounting the inner dome
(
A Pg. 30)
After setting is complete, mount
the inner dome to the camera.
step 7
Mounting the dome cover
(
A Pg. 30)
Insert the silica gel into the
designated space to prevent
fogging of the dome cover,
followed by mounting the dome
cover.
TK-C215VP4_JP.book Page 19 Thursday, November 2, 2006 10:51 AM