JVC TK-C215VP4U/E - Manual (Page 30)

30
Installation and Connection
After setting is complete, mount the inner dome
to the camera.
1.
Mounting the inner dome
Mount the inner dome to the 3 clips.
Note:
● Mount the inner dome such that it does not
cover the lens.
● When mounting the inner dome, make sure
not to move the position of the lens. Doing so
may cause the preset angle of view to go out
of alignment.
1.
Cleaning the dome cover
Before mounting, remove any dust or dirt from
the dome cover.
Memo:
● Dirt that is not removed from the cover before
mounting may appear on the camera’s
image.
Memo:
● Do not apply excessive force to the dome
cover such as stretching it.
2.
Mounting the dome cover to the base
Mount the dome cover by aligning the 3 position
marks on the base with the dome cover.
3.
Fastening the dome cover
Fasten by tightening the 3 fastening screws of
the dome cover using the wrench supplied.
Mounting the inner dome
Clip(x 3)
Inner
Dome
*TK-C215VP4 is used in the above illustration
Mounting the dome cover
2
3
Position Alignment Mark (x 3)
Wrench
(Supplied)
*TK-C215VP4 is used in the above illustration
TK-C215VP4_JP.book Page 30 Thursday, November 2, 2006 10:51 AM