JVC VN-V25U - Manual (Page 17)

17
Electricity can be supplied to this product either
by connecting to the AC 24 V power supply or
using the PoE (
A Page 18).
ⅷ When power is supplied to this product, the
[STATUS] indicator at the side lights up. The
indicator lights up in orange color during
startup, and switches to green color after
startup is complete.
You can select not to light up the [STATUS]
indicator when the unit is running.
Caution:
● Make sure to select only one mode of electrical
supply. Connecting the power cord and the
LAN cable for the PoE at the same time may
result in failure or malfunction of the camera.
● Be sure to use an AC 24 V supply that is
isolated from the primary power supply
circuit. Using a variable voltage power supply
will cause the camera and system to
malfunction or breakdown.
Connecting to the AC 24 V power
supply
Connect this product to the AC 24 V power
supply when the PoE is not used.
Caution:
● Make sure to select only one mode of electrical
supply. Connecting the power cord and the
LAN cable for the PoE at the same time may
result in failure or malfunction of the camera.
● The unit is to be powered by an AC 24 V
power supply.
The AC 24 V power supply should conform to
the following: Class 2 only (For USA),
Isolated power supply only (For Europe and
others).
ⅷ Power cord
● To prevent misconnection and detachment of
cords, use a lug plate to connect the cord to
the terminal.
● When a two-core VVF (vinyl insulated vinyl
sheath cable) is used, the connection
distance is as follows. (Reference value)
Note:
● After DHCP timeout, all IP addresses of
VN-V25U/26Us are set to 192.168.0.2 by default.
When the power of multiple cameras within the
same LAN environment are turned on at the
same time, the IP address of the cameras
overlap, thus preventing proper access. As such,
make sure to turn on the power of the cameras
one by one.
Power Connection
CAUTION : NEVER USE PoE AND AC 24V AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
SEE INSTRUCTION MANUAL
CLASS
2
O
NL
Y
F OR
USA
ISOLA
TED
PO
WER
ONL
Y
FOR
E UR
OPE
A ND
O T HER
MONITOR
OUT
10BASE-T/
100BASE-TX
PUSH
OUTPUT
INPUT
2
AC24V
1
Po
E
G 2 1 2 1
ALARM
To Power
Supply
Conductor Diameter
(AWG No.) R1.0 mm
(18) and
above R1.6 mm
(14) and
above R2.0 mm
(12) and
above
Maximum
Extension VN-V25U 150 m 400 m 630 m
VN-V26U 90 m 240 m 370 m
Warning
The rated power of this product is AC 24 V,
50 Hz/60 Hz. Make sure to use it with the
correct voltage.
Use an AC 24 V supply that is isolated from
the primary power supply.
Supplying a power beyond the rated value
may result in failures, smoke or fire. When the
camera breaks down, turn off the power and
contact our service center immediately.
When a power beyond the rated value is
supplied, the internal components may be
damaged even if no abnormality is found on
the appearance and operation of the camera.
Please contact our service center immediately
for servicing (charged separately).
STATUS
MONITOR OUT
IRIS
PAL OFF NTSC RESET
Status Indicator
VN-V25U_26U_EN.book Page 17 Monday, January 21, 2008 10:13 AM