JVC VN-V25U - Manual (Page 21)

21
Use the screw hole on the camera mounting
bracket to mount this camera to a fixer or
rotating platform.
Ⅵ Mounting the camera mounting
bracket on the top of the camera
Caution:
● When mounting the camera, use screws with
a length between 5 mm to 7 mm from the
mounting surface. Screws beyond the
specified length may damage the interior,
while those shorter than specified may cause
the camera to fall off, and therefore these
must not be used.
Caution:
● The camera mounting bracket is mounted on
the bottom surface of the camera by default.
To mount it to the top surface, do so by
removing the two fastening screws from the
camera mounting bracket. Make sure to
fasten the screws firmly.
Mounting the Camera
Camera
Mounting
Screw Hole
1/4-20UNC
Camera Mounting
Bracket Fastening Screw
(2 pcs: M2.6 x 6 mm)
Anti-rotation Hole
Fall
Prevention
Wire
Camera
Mounting
Bracket
M3x6 mm
(15/64 inch)
6 mm
2 mm and below
Camera
Mounting
Bracket
5 mm and
above
7 mm and
below
1/4-20UNC
2 mm and below
VN-V25U_26U_EN.book Page 21 Monday, January 21, 2008 10:13 AM