Jaguar X-Type JJM 21 02 20/15 - Manual (Page 112)

5-8 Climate control
To switch the system on
The climate control system operates in
position II (run) of the ignition switch.
With the ignition key turned to the run
position, the system will switch on in the
operating mode last set.
For normal usage select AUTO mode.
AUTO mode
Automatic operation provides a
controlled environment over a
temperature range of 17°C (61°F) to
31°C (89°F) and should be regarded as the
normal operating mode.
To select automatic climate
control press the AUTO button;
the word AUTO appears on the
LCD screen to confirm selection.
Select the required temperature.
Front and rear screen heating and timed
air recirculation may be selected in
AUTO mode. Selecting any other control
will cancel AUTO operation.
Automatic operation cannot be
deselected using the AUTO button.
To exit AUTO mode, select another mode
or press the fan control knob to switch
the system off.
Temperature selection
Set the required interior
temperature with the red
and blue arrowed
buttons. Press the red button to increase
temperature and the blue button to
decrease temperature.
The selected temperature will appear on
the lower part of the LCD screen.
Pressing the buttons to select the
maximum or minimum temperature
settings causes the display to change
to HI or LO respectively and cancel
AUTO mode.
To quickly jump from HI or LO to a
convenient midrange temperature of
23°C (73°F), press and hold AUTO for a
few seconds.
External temperature
The external (EXT) temperature is
displayed at the top of the screen.
Celsius/Fahrenheit selection
Press the button to change the
scale between degrees Celsius (°C)
and degrees Fahrenheit (°F) for the
displayed internal and
external (EXT) temperatures.
Air recirculation
Timed air recirculation
Press the button briefly to select
timed air recirculation.
The fresh air intake is opened
and the button LED extinguished at the
end of the time out period.
Latched air recirculation
Press and hold the button for a
few seconds to select latched air
recirculation. Selection is
indicated by the screen symbol, two
beeps and the button LED flashing four
times then remaining illuminated.
Selecting latched air recirculation cancels
AUTO operation.
To deselect latched air recirculation,
press the recirculation button again, or
select AUTO.
!
WARNING:
Prolonged operation with
recirculation selected in cold, damp
conditions could result in interior
condensation.