Jaguar X-Type JJM 21 02 20/15 - Manual (Page 31)

Security and locks 2-13
Press and hold the programmed
HomeLink button to activate the
programmed device and release when the
device begins to activate.
If, after 90 seconds, the indicator light
does not flash rapidly, release both the
HomeLink and the hand-held transmitter
buttons and repeat the procedure starting
with Step 2. However, position the
hand-held transmitter at a different angle
and/or distance.
If the device does not operate you may
need to complete the steps outlined in
‘Rolling code programming’.
Some entry gates and garage door
openers may require you to replace
Step 4 with the procedures in the section
‘Canadian Programming’.
If you are programming a rolling code
equipped device, continue with the
procedures outlined in ‘Rolling code
programming’.
Note: Keep the original transmitter for
future use or programming procedures if,
for example, you purchase a new vehicle.
Caution: It is recommended that
when you sell or dispose of the
vehicle, the programmed HomeLink
buttons be erased for security
purposes.
Canadian programming/
Gate programming
Canadian frequency laws, and the
technology of some entry gates, require
you to press and re-press (cycle) the
hand-held transmitter button every two
seconds during programming.
Continue to press and hold the desired
HomeLink button while you cycle your
hand-held transmitter until the indicator
light flashes rapidly.
Note: When programming a garage door
opener or entry gate, unplug the device
during the ‘cycling’ process to prevent
possible motor failure.
Rolling code programming
Rolling code garage door openers (or
other rolling code devices) which are
‘code protected’ may be determined by
the following:
• reference the device owner’s
instruction manual for verification.
• the hand-held transmitter appears to
programme the HomeLink Universal
Transceiver but does not activate the
garage door.
• press and hold the trained HomeLink
button. The device has the rolling
code feature if the HomeLink
indicator light flashes rapidly and
then turns solid after two seconds.
To train a garage door opener or other
device with the rolling code feature,
follow these steps after completing the
Programming section instructions.