On the road 4-37, Manual transmission – Jaguar X-Type JJM 21 02 20/15 User Manual

Page 93

Advertising
background image

On the road 4-37

Sport mode

The switch marked ‘S’ on the ‘J’-gate

surround enables the driver to select

either normal ‘N’ or sport ‘S’ modes.
When sport mode is selected the

automatic transmission will operate

normally, but the gear shift points are

extended to make full use of the engine’s

power reserves.
To select ‘Sport’, press the switch. A red

light within the switch is illuminated to

indicate that sport mode has been

selected.
To cancel ‘Sport’, press the switch again.

Note: Both sides of the ‘J’-gate can be

used irrespective of the transmission

mode, e.g. with ‘S’ selected the

transmission can be operated in full

automatic or by manual selection.
In addition to the ‘switched’ transmission

modes (‘N’ and ‘S’) the transmission

control module will select shift patterns

to suit specific conditions.
Cruise Control – When cruise control is

operating at set speed the transmission

selects a shift pattern to suit cruise

control operation.
DSC/Traction control – When

DSC/traction control is switched ON and

the system is activated, the transmission

selects a shift pattern to suit traction

control conditions.
Gradients – When the vehicle is being

driven on roads with uphill gradients, the

transmission adapts the shift pattern to

make better use of engine power and aid

engine cooling.
Note: Under the conditions described

above, the relevant transmission mode

will override the ‘N’ or ‘S’ modes selected

by the driver. When such conditions no

longer exist, e.g. Cruise Control switched

OFF, the transmission will revert to the

shift pattern previously selected by the

driver, i.e. ‘N’ or ‘S’.

Manual transmission

Gear selector lever

A diagram of the gear shift pattern is set

in the top of the lever knob.
Depress the clutch pedal completely

when changing gear. To avoid excessive

clutch wear do not drive with your foot

resting on the clutch pedal.
To select reverse gear, pull up the ring

below the gear knob (A), then move the

lever to the reverse position.

Caution:

Do not select reverse gear

while the vehicle is moving forwards.

Advertising