JVC GET0570-001A - Manual (Page 158)

4
Connecting the external amplifier or subwoofer/
You can connect an amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it
can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker
leads of this unit unused.
•
•
B
Rear speakers
Remote lead
Remote lead (blue with white stripe)
To the remote lead of other equipment or automatic
antenna if any
Y-connector (not supplied for this unit)
Y-
Front speakers
JVC Amplifier
JVC
Signal cord (not supplied for this unit)
JVC CD
JVC
CD CD-CH CH-X1500
JVC
•
Bluetooth Bluetooth KS-BTA200
iPod iPod KS-PD100
KS-U57
3.5 mm AUX KS-U58
Connecting the external components /
When connecting the external components, refer also to the manuals supplied for the components and
adapter.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC component Model name
CD changer (CD-CH) CH-X1500, etc.
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component Adapter Model name
Bluetooth device Bluetooth adapter KS-BTA200
iPod Interface adapter for iPod KS-PD100
Portable audio player with line output jacks Line input adapter KS-U57
Portable audio player with 3.5 mm stereo mini jack AUX input adapter KS-U58
When connecting more than one component (maximum: two), it is recommended that you connect the
components in series as explained below.
CD changer jack / CD
When connecting two components in series /
A KS-BTA200
B *
4 CD-CH / KS-PD100 / KS-U57 / KS-U58
* 4
To disconnect the connector /
Hold the connector tightly ( 1 ), then pull it out ( 2 ).
1 2
* 3 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint
(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
* 4 To use these components, set the external input setting correctly (see page 22 of the INSTRUCTIONS).
iPod Apple Inc.
* 3
* 4 22
C
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
Set “L/O MODE” to “REAR” (See page 22 of the
INSTRUCTIONS.)
L/O MODE REAR
22
Set “L/O MODE” to “SUB.W” (See page 22 of the
INSTRUCTIONS.)
L/O MODE SUB.W
22
Subwoofer
or
JVC Amplifier
JVC
Install2_KD-R406[UT]_CT_1.indd 4 Install2_KD-R406[UT]_CT_1.indd 4 2008.9.3 2:40:54 PM 2008.9.3 2:40:54 PM