JVC GET0570-001A - Manual (Page 183)

ENGLISH
25 SETTINGS
Category Menu items Selectable settings, [reference page]
AUDIO
FADER * 9
Fader
R06 – F06 : Adjust the front and rear speaker output balance.
[Initial: 00]
BALANCE * 10
Balance
L06 – R06 : Adjust the left and right speaker output balance.
[Initial: 00]
LOUD
Loudness • LOUD OFF
• LOUD ON : Cancels.
: Boost low and high frequencies to produce a
well-balanced sound at a low volume level.
VOL ADJUST
Volume adjust VOL ADJ –05 —
VOL ADJ +05
[Initial: VOL ADJ 00] : Preset the volume adjustment level of each source (except
FM), compared to the FM volume level. The volume level
will automatically increase or decrease when you change
the source.
• Before making an adjustment, select the source you
want to adjust.
• “VOL ADJ FIX” appears on the display if “FM” is selected
as the source.
L/O MODE
Line output mode • SUB.W
• REAR
: Select if the REAR LINE OUT terminals are used for
connecting a subwoofer (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for
connecting the speakers (through an external amplifier).
SUB.W FREQ * 11
Subwoofer cutoff
frequency
• LOW
• MID
• HIGH : Frequencies lower than 72 Hz are sent to the subwoofer.
: Frequencies lower than 111 Hz are sent to the subwoofer.
: Frequencies lower than 157 Hz are sent to the subwoofer.
SUB.W LEVEL * 11
Subwoofer level
SUB.W 00 —
SUB.W 08 : Adjust the subwoofer output level.
[Initial: SUB.W 04]
BEEP
Keypress tone • BEEP OFF
• BEEP ON : Deactivates the keypress tone.
: Activates the keypress tone.
AMP GAIN * 12
Amplifier gain
control
• LOW POWER
• HIGH POWER
: VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speaker.)
: VOLUME 00 – VOLUME 50
* 9 If you are using a two-speaker system, set the fader level to “00.”
* 10 This adjustment will not affect the subwoofer output.
* 11 Displayed only when “ L/O MODE” is set to “SUB.W.”
* 12 The volume level automatically changes to “VOLUME 30” if you change to “ LOW POWER” with the volume level
set higher than “VOLUME 30.”
Continued on the next page
EN22-29_KD-S26[J]f.indd 25 EN22-29_KD-S26[J]f.indd 25 7/7/09 12:24:55 PM 7/7/09 12:24:55 PM