Vcr set up 2 – JVC HM-HDS1EU User Manual

Page 77

Advertising
background image

Masterpage:Right-Full-NoTitle0

EN

77

Filename [HDS1EU_5.fm]

Page 77

June 21, 2001 12:30 pm

VCR SET UP 2

* The default setting is bold in the table below.

8

B.E.S.T.

ON
OFF

You can set the B.E.S.T. (Biconditional Equalised Signal Tracking) system to
“ON” or “OFF” (

੬

pg. 41).

8

PICTURE CONTROL

AUTO
EDIT
SOFT
SHARP

This feature helps you to adjust the playback picture quality according to your
preference. Normally select “AUTO”.

AUTO:

Provides the optimised picture benefits of the B.E.S.T. Picture
System.

EDIT:

Minimizes picture degradation during editing (recording and
playback).

SOFT:

Reduces image coarseness when viewing overplayed tapes
containing a lot of noise.

SHARP:

Clearer, sharper-edged picture when viewing images with lots
of flat, same-coloured surfaces such as cartoons.

NOTES:

● When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until

you select another mode.

● When you select “EDIT” to dub tapes, be sure to select “AUTO” after you finish

dubbing the tapes.

● When “B.E.S.T.” is “OFF”, “PICTURE CONTROL” switches automatically from “AUTO”

to “NORM”.

8

DIGITAL 3R

ON
OFF

When this function is set to “ON”, the Digital 3R picture system applies edge
correction to the luminance signal to enhance detail.

NOTES:

● Normally it is recommended to keep “DIGITAL 3R” set to “ON”.

● Depending on the type of tape being used, picture quality may be better with “DIGITAL

3R” set to “OFF”.

● If you use the recorder as the source player for editing, be sure to set “DIGITAL 3R” to

“OFF” before starting.

8

DIGITAL TBC/NR

ON
OFF

Your recorder is equipped with the Digital TBC (Time Base Corrector) that
removes jitter from fluctuating video signals to deliver a stable picture even with
old tapes and rental cassettes.
The on/off of Digital 3-DNR (Noise Reduction) which cuts noise and enables
clear picture reproduction is also linked to this function.
We recommend that you set “DIGITAL TBC/NR” to “ON” when...
... playing back a tape recorded on a camcorder.
... playing back a tape repeatedly used.
... using this video recorder as the source player for editing.

NOTES:

● If you play back a tape recorded under poor TV reception condition, the picture may

become more stable with Digital TBC/NR set to off.

● When “DIGITAL TBC/NR” is set to “ON”, if you play back a tape where certain types of

signals are recorded (using a PC or some character generators), the playback picture
may be distorted. If this is the case, set “DIGITAL TBC/NR” to “OFF”.

● When playing back a MESECAM tape, Digital TBC/NR does not function even though

“DIGITAL TBC/NR” is set to “ON”.

HDS1EU_.book Page 77 Thursday, June 21, 2001 12:30 PM

Advertising