JVC HR-DD949EE - Manual (Page 42)

42
EN
Fine-Tuning Channels
Already Stored
SELECT STATION NAME
CHARACTER
2
Press PUSH JOG and the first letter of the station
name begins blinking.
ENTER NEW CHARACTER
3
Press PUSH JOG %fi to cycle through the characters
(A–Z, 0–9, –, * , +, (space)) and stop when the
desired one is indicated, then press PUSH JOG to
enter. Enter the remaining characters the same way
(maximum of 4).
After entering all characters, press OK.
● Repeat steps 1 through 3 as necessary.
● If you make a mistake, press PUSH JOG until the
incorrect character begins blinking. Then enter the
correct character by pressing PUSH JOG
%fi .
CLOSE CONFIRMATION
SCREEN
4
Press MENU.
%
%
%
]
Set Stations (A)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 40 to access the Confirmation screen before continuing.
TUNER SET (cont.)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 40 to access the Confirmation screen and then perform
step 1 of "Set Stations (A)" above before continuing.
Set Stations (B)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 40 to access the Confirmation screen before continuing.
SELECT CHANNEL TO
FINE-TUNE
1
Press PUSH JOG %fi until the channel you want to
tune begins blinking.
ACCESS MANUAL CH. SET
SCREEN
2
Press OK three times. The Manual Ch. Set screen
appears.
PERFORM TUNING
3
Press PUSH JOG %fi until the picture is its clearest.
Then press OK.
● The Confirmation screen appears.
● Repeat steps 1 through 3 as necessary.
CLOSE CONFIRMATION
SCREEN
4
Press MENU.
%
%
SELECT ITEM
1
Press PUSH JOG
%fi until the item you want begins
blinking. Then press OK twice and the station’s name or
"- -" begins blinking.
SELECT NEW STATION
2
Press PUSH JOG
%fi until the new station’s name (ID)
you want to store begins blinking.
Registered station names (
੬
pg. 43) appear as you
press PUSH JOG
%fi.
SWITCH STATIONS
3
Press OK.
● Repeat steps 1 through 3 as necessary.
CLOSE CONFIRMATION
SCREEN
4
Press MENU.
%
%