JVC HR-DD949EE - Manual (Page 44)

44
EN
TROUBLESHOOTING
Before requesting service for a problem, use this chart and see if you can repair the trouble yourself. Small problems are often easily
corrected, and this can save you the trouble of sending your video recorder off for repair.
POSSIBLE CAUSE
● The mains power cord is discon-
nected.
● “‰“ is displayed on the display
panel with Auto Timer set to "OFF".
● The batteries are discharged.
● The remote control is set to the
wrong code.
● The remote control is set to the
wrong operating mode.
SYMPTOM
1. No power is applied to the
recorder.
2. The clock is functioning properly,
but the recorder cannot be
powered.
3. The remote control won’t function.
CORRECTIVE ACTION
Connect the mains power cord.
Press the TIMER button to turn the
“‰“ indicator off.
Replace the dead batteries with new ones.
Re-perform the A/B Code setting
(
੬
pg. 15).
Set the TV/SAT/VCR switch to correct
position.
SYMPTOM
1. The tape does not run during
recording.
2. The tape stops during rewind or
fast-forward.
3. The tape will not rewind or fast-
forward.
CORRECTIVE ACTION
Press PLAY to turn the “^“ indicator
off.
Press C.MEMORY to deactivate the
Counter Memory function and turn
the “
M “ indicator off.
Check the cassette.
SYMPTOM
1. The playback picture does not
appear while the tape is running.
2. Noise appears during normal
playback.
3. Noise appears during slow-motion
playback.
4. Noise appears during still play-
back.
5. Breaks are noticeable in Hi-Fi
soundtrack.
6. The playback picture is blurred or
interrupted while TV broadcasts are
clear.
7. No sound accompanies the
playback picture with RF
connection.
POSSIBLE CAUSE
● If you’re using the RF OUT connec-
tion . . .
. . . the TV receiver’s channel selector
is not set to the VIDEO channel.
. . . the recorder's VIDEO channel
has not been correctly set.
● If you’re using the AV connection, the
TV receiver is not set to the AV mode.
● The automatic tracking mode is
engaged.
● The automatic tracking mode is
engaged.
● Automatic tracking is engaged.
● The video heads may be dirty.
● The TV system you have selected is
incorrect.
CORRECTIVE ACTION
If you are using the RF OUT connec-
tion . . .
. . . set the TV receiver to the VIDEO
channel. (
੬
pg. 6)
. . . Perform "Video Channel Set"
(
੬
pg. 6)
If you are using the AV connection,
set the TV to its AV mode.
Try manual tracking. (
੬
pg. 12)
Try manual tracking. (
੬
pg. 12)
Press TV PROG + or – a few times to
remove the noise bars from the screen.
Engage and adjust tracking manually.
(
੬
pg. 12)
Consult your JVC dealer.
Set it to the correct position for the
TV broadcast system used in your
area. (
੬
pg. 6.)
POSSIBLE CAUSE
● “^“ is displayed on the display
panel.
● “
M “ is displayed on the display
panel.
● The tape is already fully rewound or
fast-forwarded.
POWER
TAPE TRANSPORT
PLAYBACK