Jaguar SEMCON JLR XJ - Manual (Page 53)

R
(FM8) SEMCON JLR OWNER GUIDE VER 1.00 NAS
LANGUAGE: english-NAS-en; MARQUE: jaguar; MODEL: XJ
Garage door opener
53
Garage door opener GARAGE DOOR TRANSCEIVER
Do not use the transceiver with any garage
door opener that lacks the safety stop and
reverse feature as required by safety
standards.
When programming the transceiver to a
garage door opener or entry gate, ensure the
area is clear. This will prevent potential
personal injury or vehicle damage as the gate
or garage door will activate during the
programming.
This device may suffer from interference if
operated in the vicinity of a mobile or fixed
station transmitter. This interference is likely to
affect the hand-held transmitter as well as the
in-car transceiver.
The door transceiver is located in the rear-view
mirror. It can be programmed to transmit the
radio frequencies of up to three different
transmitters, which can be used to activate
garage doors, entry gates, home lighting,
security systems or other radio frequency
operated devices.
Although this section mainly describes the
procedures for a garage door opener, it also
equally applies to the previously mentioned
applications.
In some countries, this feature is also known
as the HomeLink® Universal Transceiver. The
transceiver radio frequency approval numbers
for the USA, Canada and Mexico are shown
below:
USA and Puerto Rico - FCC: K8597R315.
Canada - CAN: 2145 101 790A.
Mexico - CFT/D04/AGIT/DGIH/HOM/6068/01
and 7335/01.
For further information, see 55,
INFORMATION AND ASSISTANCE.
BEFORE PROGRAMMING
When programming a device that may require
you to press and re-press the hand-held
transmitter (cycle), unplug the device during
the cycling process to prevent possible motor
failure.
For best results, fit a new battery to the
hand-held transmitter of the garage door
opener (or other device) before programming.
If your garage door opener receiver (located in
the garage) is equipped with an antenna,
ensure that the antenna is hanging straight
down.
PROGRAMMING
Ensuring that the engine is switched off:
1. Ensure that the ignition system is on.
2. Hold the end of the original garage door
opener hand-held transmitter 2 to 6 inches
(50 to 150 mm) away from the transceiver
in the rear-view mirror, keeping the
indicator lamp in view.