JVC GET0056-001A - Manual (Page 16)

16
ENGLISH
REMOTE OPERATIONS
Installing the battery
When the controllable range or effectiveness of the
remote controller decreases, replace the battery.
1
Remove the battery holder.
1)
2)
1) Push out in the direction indicated by the
arrow using a ball point pen or a similar tool.
2) Remove the battery holder.
2
Place the battery.
Slide the battery into the holder with the + side
facing upwards so that the battery is fixed in
the holder.
Before using the remote controller:
• Aim the remote controller directly at the
remote sensor on the main unit. Make sure
there is no obstacle in between.
• Do not expose the remote sensor to strong
light (direct sunlight or artificial lighting).
Remote sensor
(back side)
3
Return the battery holder.
Insert again the battery holder pushing it until
you hear a clicking sound.
WARNING:
• Store the batteries in a place which children
cannot reach.
If a child accidentally swallows the battery,
immediately consult a doctor.
• Do not recharge, short, disassemble or heat
the batteries or dispose of in a fire.
Doing any of these things may cause the
batteries to give off heat, crack or start a
fire.
• Do not leave the batteries with other
metallic materials.
Doing this may cause the batteries to give
off heat, crack or start a fire.
• When throwing away or saving the
batteries, wrap in tape and insulate;
otherwise, it may cause the batteries to give
off heat, crack or start a fire.
• Do not poke the batteries with tweezers or
similar tools.
Doing this may cause the batteries to give
off heat, crack or start a fire.
Lithium coin battery
(product number:
CR2025)
(back side)
EN16-17KS-FX611[U]-9 11/1/01, 3:18 PM 16