JVC KD-LX50 - Manual (Page 35)

35
ENGLISH
STOP
PLAY
To operate the system in the User Word mode
Make sure to set “VOICE WORD” to “USER” by following steps 1 to 4 on page 27.
Then follow the procedure below.
1 Press VOICE to turn on the receiver.
2 Press VOICE again to activate the Voice Recognition System.
3 Speak one of the Operation Commands or of the Access Commands you have stored to
the microphone while “SPEAK” is flashing on the display.
•
For example, to use Access Command number 14, speak “Jazz 89” (which you have
registered previously.)
4 Press + or – to adjust the volume.
To check the registered voice and stored operations
Follow the procedure below.
1 Press and hold VOICE until one of the Access Commands appears on the display.
2 Press + or – to confirm the command contents.
• Each time you press + or –, the commands appear on the display in sequence.
You can check the command contents on the display.
The recorded voice is also reproduced.
If you want to check the recorded voice again
Press VOICE while the voice command number you want to confirm is selected.
3 Press and hold VOICE again to finish the checking.
EXAMPLE: A station of 89.5 MHz
is stored in the Access Command
14 (with sound mode — “SOFT”)
EXAMPLE: Disc no. 01 of the CD
changer is stored in the Access
Command 15 (without any sound
mode)
EN22-39.KD-LX50[J]/f 00.3.15, 4:13 PM 35