JAI CV-M77 - Manual (Page 20)

CV-M77
The SW301 switches (1-3) in “ON” position activates 75 Ω termination of ext.HD and ext.VD signals
and it activates 75 Ω termination of an ext.trigger signal. The factory setting is “OFF” enabling TTL
signal termination for all three signals.
8.2.2 SW302
switch
S302
OFF ON
White - 1 xxxx
Balance 2 xxxx
Sync. on G: 3 xxxx
WEN: 4 xxxx
The SW302 switch has the following functions: The switches (1-2) determines the color
temperature, the switch (3) activates Composite sync. on the green video signal and the switch (4)
outputs the WEN signal at the DSUB connector.
The white balance is dependent on the color temperature of the light. The available settings are:
S302-1 S302-2 Color
temperature
OFF OFF 2800-5600K (factory setting)
OFF ON Invalid setting
ON OFF 4600K
ON ON 5600K
The S302-3 switch adds in “ON” position the composite sync. signal to the green video signal. The
factory setting is “OFF” leaving the green RGB signal without sync. signals.
The S302-4 switch outputs in “ON” position the WEN signal via pin 7 of the 9-pin DSUB connector.
The factory setting is “OFF”. In the “OFF” position the camera outputs the composite sync. signal
via pin 7 of the 9-pin DSUB connector.
8.2.3 SW303
switch
S303
output ↔ input
OFF ON
HD: 1 Xxxxx
VD: 2 xxx
The SW303 switch switches between output of internal HD/VD signals and input of external HD/VD
signals. The factory setting is input of external HD/VD signals (SW303-1 and SW303-2 in “ON”
position). The “ON” position is towards switch SW301.
- 20 -