JAI CV-M77 - Manual (Page 8)

CV-M77
See section 8 “Switch Settings” and section 9 “Jumper Settings ” for more information.
*) When using the WEN signal from the 6 pin connector do not use the same signal from the
9 pin connector.
*) Signals shown in bold italics are factory settings.
5.3 9-pin DSUB-connector (RGB/SYNC.)
Pin No. 5.3.1.1 Signal 5.3.1.2 Remarks
1* NC VD input: JP303 “open” and JP304 “short”
2 GND
3 R output
4* G output Sync. on G: SW302-3 “ON”
5 B output
6* HD input HDinput: SW303-1 “ON”. HDout: SW303-1 “OFF”
7* Sync output WEN output: SW302-4 “ON”
8 GND
9* NC PCLK output: JP305 “open” and JP306 “short”
Notes:
*)
Signals on pin no. 1,4, 6,7 and 9 can be changed by jumper setting.
See section 8 “Switch Settings” and section 9 “Jumper Settings ” for more information.
*) In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.
*) When using the HD/VD, PCLK and WEN signals (input or output) from the 9-pin D-SUB
connector do not use the same signals (input or output) from the 12 pin or 6 pin
connectors.
*) Signals shown in bold italics are factory settings.
- 8 -