JVC HR-J631T - Manual (Page 28)

28
G-Code Timer
Programming
TIMER RECORDING (cont.)
LOAD A CASSETTE
1
Make sure the record safety tab is present.
● The VCR’s power comes on automatically.
● If you’re watching on channel 13, press TV/VIDEO to
select the VIDEO mode. VIDEO is displayed on the
front display panel.
ACCESS G-CODE SCREEN
2
Press MENU on the remote
control.
● The clock must be set in
order to access the G-
Code screen. If you
haven’t set the clock, the
Main Menu screen
appears when you press
MENU. Refer to page 5 for the clock setting proce-
dure.
ENTER G-CODE NUMBER
3
Press the appropriate NUMBER keys to enter the G-Code
number printed in the TV listings for the TV program you
wish to record.
● To make corrections, press CANCEL and input the
correct G-Code number.
● If the G-Code number you input is incorrect,
"ERROR" may appear on the screen to advise you of
the error. This happens when the G-Code number is
for a program which has already passed. "ERROR" is
displayed for about 4 seconds and the G-Code screen
reappears (step 2).
CHECK INPUT DATA
4
Press OK and the Program
screen appears.
The G-Code number you
entered appears in the
Program screen. Check to
make sure it’s accurate.
● To timer-record daily or
weekly serials, press
DAILY (NUMBER “8”) or WEEKLY (NUMBER “9”).
“DAILY” or “WEEKLY” appears on the Program
screen.
● If you made a mistake, press CANCEL and, after
pressing MENU as many times as necessary to access
the G-Code screen, input the correct G-Code number.
SET TAPE SPEED
5
Press SP/EP.
G-CODE
PRESS NUMBER KEY(0-9)
PRESS (MENU) TO MAIN MENU
PROGRAM 1
(G-CODE 12345678)
DATE 7/10 WED
START 8:00 PM
STOP 9:00 PM
CHANNEL 8 SP
PRESS (8=DAILY, 9=WEEKLY
SP/EP=REC SPEED)
PRESS (MENU) TO END
1 2 3
4 5 6
7 8 9
0
1 2 3
4 5 6
7 8 9
0
NUMBER "9"
CANCEL
NUMBER
NUMBER "8"
TV/VIDEO
SP/EP
TV/VCR
OK
MENU
Before G-Code Timer programming, see "G-Code Setup" on
page 9.
6
q
OK