JVC HR-J631T - Manual (Page 30)

30
On-Screen
Timer
Programming
TIMER RECORDING (cont.)
You can directly program the VCR’s timer to record up to 8
shows, as far as a year in advance. Remember, the clock must
be set before you can program the timer (
੬
pg. 5).
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover
the hole with adhesive tape, then load.
● The VCR comes on, and the counter is reset,
automatically.
● If watching channel 13, press TV/VIDEO to select the
VIDEO mode. VIDEO is displayed on the front display
panel.
ACCESS ON-SCREEN
MENU
2
Press MENU as many times as necessary to bring up the
Main Menu screen.
ACCESS PROGRAM SET
SCREEN
3
Make sure the arrow is to
the left of "PROGRAM
SET", then press OK.
SELECT PROGRAM
NUMBER
4
Press the appropriate NUMBER keys or CH 5∞ to select a
vacant program number, then press OK. The first time you
do this, all numbers will be vacant, so just press OK when
the screen appears
SET PROGRAM
INFORMATION
5
Press the appropriate NUMBER keys to set the date,
start/stop time and channel number. Press CH
5∞ to set
AM/PM and tape speed. Press OK after AM/PM,
channel number and tape speed settings. The next
setting that can be set begins flashing.
● Any information comprised of 1 digit (except the
channel number) should have a "0" entered before it.
● It is possible to set all information using the CH5∞
button. (In this case, press OK after each setting.)
** You can record selected programs at the same time
every weekday, or once a week. Before entering the
month, press NUMBER key “8” (DAILY) or “9”
(WEEKLY). Either "DAILY" or "WEEKLY" appears.
Press again and "DAILY" or "WEEKLY" disappears.
PROGRAM 1
DATE - - / - -
START - - : - - AM
STOP - - : - - AM
CHANNEL - - SP
PRESS NUMBER KEY(0-9)
OR ( 5,∞), THEN (OK)
PRESS (MENU) TO END
1 2 3
4 5 6
7 8 9
0
1 2 3
4 5 6
7 8 9
0
6
q
MENU
CH
CH
NUMBER
NUMBER "8"
NUMBER "9"
OK
TV/VIDEO
OK
MENU