Three step quick start 11, Select the video channel when, Turn the vcr off and then on again. re-perform – JVC HR-J580EK User Manual
Page 11: Rf c able only, Rf and sc art connection, Oops, Auto setup, Step 2
three step quick start
11
REVIEW
VCR
REVIEW
VCR
SELECT THE VIDEO CHANNEL
When
Auto Setup
has finished, you will see the following display panel on your
VCR:
rf c able only
If you have only used the RF
Cable to connect the VCR to the TV, you will
see this display. The number is the channel on
the TV that the
Auto Setup
has chosen to be the
video channel. In the example, we have presumed that channel 36 is vacant and
have set the VCR to 36:
Now tune the TV set to channel 36 (refer to TV manual if
necessary); you should see two vertical white bars appear
on the TV screen. If the bars do not appear or are not
clear, choose another vacant channel and try again. If you
cannot obtain the vertical white bars on any channel
between 22 and 69, consult your local JVC dealer.
rf and sc art connection
If you have
chosen to connect the VCR to the TV with both
the RF Cable and a 21-pin SCART Cable (not
provided), you need to press the
PR
button on
the Remote Control until the figure reads ‘– –’. This is because you will use the
TV in AV mode to view video pictures and therefore do not need a dedicated
video channel.
FINISH AUTO SETUP
Press O and move on to
Step 2
to check the results.
oops!
If there is a power cut or you accidentally press a button during
Auto
Setup
, turn the VCR off and then on again. Re-perform
Auto Setup
.
TE
PR
TV PR +
TV PR –
T
V
–
TV
+
TV
0000
STOP
FIN
MENU
OK
TV/VCR
DAILY/QTDN.
VPS/PDC
AUX
?
WEEKLY/HEBDO
PROG
30 SEC
– –:– –
AUDIO
1
2
3
4
6
5
7
8
9
0
DATE
START
DEBUT
PR
2
4
1
3
ENTER/ENTR
EE
EXPRESS
PR +
OK
3
ENTER/ENTR
EE