JVC KY-F75 - Manual (Page 20)

E16
2. Preparations (continued)
Connecting the AC adapter
It is possible to supply power to the KY-F75 from the computer via the IEEE1394 cable, but when
a motorized lens, etc., is used, the DC cable should be used to connect the KY-F75’s [DC IN]
connector and the [TO CAMERA] connector on the AC adapter (AA-P700).
CAUTION
• Be sure to use the AA-P700 AC adapter.
Make sure that the power switch on the AA-P700 AC adapter is set to OFF before connections are
made. Making connections while the power is ON could result in damage to the KY-F75.
Ⅵ Connecting the DC power cable and attaching the filter clamp
● After inserting the plug completely, tighten the se-
curing ring
● To reduce the emission of unwanted radio waves,
make sure to attach the provided clamp filter as
shown in the figure on the left. Wind the cable once
around the clamp filter.
● Attach the clamp filter as close as possible to the
KY-F75 as shown in the figure.
VIDEO OUTPUT
TO CAMERA S(Y/C) OUTPUT
DC 12V=OUTPUT
EITHER
OUTPUT
MAX 1.25A SEE INST-
RUCTION
MANUAL
AC 100V
AA-P700
LENS
DC IN
POWER
SEE INSTRUCTION MANUAL
REMOTE
IEEE1394
AC adapter (separately sold)
DC cable (2 m)
(separately sold)
White marking
Connect the end with the
white marking to the AC
adapter
TO CAMERA
connector
DC IN connector
Clamp filter
(supplied)
DC IN
POWER
DC IN
DC IN
Plug
Ring
Clamp filter