Jwin JT-P433 - Manual (Page 10)

Vintage Design Telephone with Caller ID V10M10_IM_EN_01282008
www.jWIN.com - 9 -
OPERATIONAL INSTRUCTIONS
Basic Setup
-continued
G. SET ALARM CLOCK
- When the LCD displays “ALARM”, press the SET/BACK button to enter
- The LCD will display “OFF” and “-1-“ (means the 1 st group of alarm clock).
Press ▲UP or ▼DOWN to select the alarm group. There are a total of
three (3) groups to be selected.
- Press the SET/BACK button to enter the setting
- Press ▲ UP or ▼DOWN to select “ONE TIME”, “P.D”(everyday) or “OFF”
- Press the SET/BACK button to confirm
- Press the SET/BACK button to enter hour setting
- Press ▲ UP or ▼DOWN buttons to select the desired alarm hour from 1
to 12 am or pm
- Press the SET/BACK button to confirm
- Use the same method to set the alarm minute
- Press the FLASH button to set the alarm time
Notes:
1. The alarm will keep around 50 seconds every time. Press any button
(except the star & SNOOZE button) or pick the handset to stop the alarm.
2. During alarm period, any incoming call will stop the alarm function
3. During alarm period, press SNOOZE to delay the alarm time. It will alarm
again after five (5) minutes. Press any button (except the star button and
SNOOZE) or put the handset to stop the alarm function.
H. SET RINGER MELODY
- When the LCD displays “RING MELODY”, press the SET/BACK button to
enter
- The LCD will display “RING MELODY” and “-01-”, press ▲UP or
▼
DOWN to select the desired melody from 01-16.
- Press the SET/BACK button to confirm
I. SET VIP RING MELODY
- When the LCD displays “VIP RING MELODY”, press the SET/BACK
button to enter
- The LCD will display “VIP RING MELODY” and “-01-”, press ▲UP or
▼
DOWN to select the desired VIP melody from 01-16
- Press the SET/BACK button to confirm
J. SET FLASH TIME
- When the LCD displays “FLASH TIME”, press the SET/BACK button to
enter
- Press ▲ UP or ▼DOWN to select the flash time among 100MS,
120MS,180MS, 270MS, 300MS, 600MS and 1000MS
- Press the SET/BACK button to confirm
K. SET PAUSE TIME
- When the LCD displays “PAUSE TIME”, press the SET/BACK button to
enter
- Press ▲ UP or ▼DOWN to select the pause time among 1S, 2S, 3S and
4S. (S=Seconds)
- Press the SET/BACK button to confirm